Electrostatic Powder Coating

PCC Plastic Coating Corporation 3465 West Mill Rd. Milwaukee, WI 53209

Telephone 414-352-2628

FAX 414-352-7514

E-Mail [email protected]

Electrostatic Powder Coatings

Powder Coated Casting

Epoxy, Polyester, Polyurethane, Urethane or Nylon Powder Coatings– These environmentally friendly protective coatings are replacing painting and plating in many operations. These thin film coatings provide decorative, tough, corrosion resistant finishes without the use of solvents and heavy metals. Powder Coating is one of our coating services and will enhance any type of metal product including castings, metal stampings and wire goods.

Powder Coatings can be formulated with special properties including

	High Temperature Resistance
	Grafitti Resistance
	Impact Resistance
	Chemical Resistance
	Friction Reducing
	Transparent Coatings
	Rust Preventative
	Textured Coatings
	Scratch Resistant

Typical Properties **

	Electrical Insulation
	Adhesion
	Tensile Strength
	Hardness
	Heat & Light Stability
	Outdoor Weathering
	Impact Resistance
	Maximum Operating Temperature
	Chemical Resistance
	Solvent Resistance
	Salt Spray Resistance

	To 1000 volts/mil
	Excellent
	7500 PSI
	To 2H
	Excellent
	Good (Polyester, Urethane)
	To 160 in/lbs.
	350 degree F
	Excellent
	Good
	Excellent


**All properties shown are typical and should not be used for specifications.

Contact Information
Telephone 414-352-2628
FAX 414-352-7514
E-Mail [email protected]

Last modified: May 2012